Nytech Heating, Cooling, and Plumbing is proud to offer you a full range of plumbing services. Even with the best home care, at some point, all homeowners face a plumbing issue. While it may be a stressful situation, particularly if it is an emergency, having a plumbing company you can depend on makes things much easier. Our licensed plumbers are ready to solve even the most complex plumbing problem.
Browse our case studies below. If you need plumbing services, give us a call today at 303-663-6840 to schedule a service call.
A longtime customer of Nytech decided it was finally time to replace their old, inefficient water heater, so they called us up to schedule a water heater replacement proposal. After going over their options, they picked the water heater that best suited their household and scheduled a replacement for the following day. We returned and removed the old water heater and installed an AO Smith 40 gallon water heater. The new unit was placed in a small pan and the expansion tank was moved into washing room, near shutoff. Our customer is excited for higher efficiency and headache-free hot water in the future!
A Total Care Club member of ours called for a demand plumbing service because their water heater was leaking out of the tank. Our plumber arrived and got straight to work assessing the problem. They discovered that the leak was coming from the side of the expansion tank body which indicates a failed expansion tank and checked the house pressure and found it at 85 psi which indicates a failed pressure regulator valve. Given the age of the water heater and presence of pressure issues, it was advised to consider a water heater and pressure regulator valve replacement for the best return on investment and peace of mind. The customer agreed, so we installed an AO Smith 50 Gallon, 40K BTU - Atmospheric Vent Water Heater and re-piped in the existing recirculation pump. We also added a new shut-off to the cold water side and two new water flexes for the water heater and installed a drain pan underneath. Our customer can enjoy their new water heater with no worries, as it is covered by all of our guarantees.
Customer called for boiler service due to the moisture sensor not working on the driveway system. Our technician performed a thorough diagnostic and found several issues including a failed ignitor, failed sensors, and a leaky boiler. Due to age and repair cost our customer decided to replace the system. We installed a new modulating boiler with a 46-gallon water heater. Our customer will enjoy years of reliable heat and hot water!
During a diagnostic visit, our technician found that the original installation of the boiler had been done incorrectly. The incorrect installation was driving up energy costs and causing comfort issues. Our customer wanted to replace the system with a new high-efficiency modulating boiler to improve efficiency, energy savings, and comfort. We completed the installation of the boiler and zoning system so our customer will enjoy years of comfort and reliable service.
Customer called for boiler service due to the moisture sensor not working on the driveway system. Our technician performed a thorough diagnostic and found several issues including a failed ignitor, failed sensors, and a leaky boiler. Due to age and repair cost our customer decided to replace the system. We installed a new modulating boiler with a 46-gallon water heater. Our customer will enjoy years of reliable heat and hot water!
A Total Care Club member scheduled their annual maintenance inspection for both their furnace and water heater, which both happened to be 22 years old. During the inspection, our techs discovered some extensive issues on the systems. To start, they flushed the water heater and didn’t detect any active leaks (which is great), but the system was very scaled up, the T and P was stuck closed, the expansion tank failed, and the PRV failed (which is not so great). Next, they moved on to the furnace cleaning and inspection. There they discovered that the blower motor and inducer motor bearings were showing early signs of mechanical failure, the flame sensor was low, the blower capacitor was out of specs, the blower assembly was dirty, and worst of all, airflow was slightly restricted and combustion overfired which was putting out high levels of CO. Because of the age of both systems and the high cost of repair, it was recommended to replace the water heater and the furnace, and a free replacement consultation was scheduled. We installed an AO Smith Signature 100 40 Gallon Atmospheric Vent Water Heater and Lennox Standard Efficiency Multi-Stage Variable Speed Furnace. This process included the removal of the old units and setting the new units level. We sealed up at all new joints on furnace, rewired in all high and low voltages on the furnace, redid the gas line adding a sediment trap, and rebuilt the flue in b-vent. On the water heater we redid the water lines adding new shut offs on hot and cold sides, installed a new expansion tank matched to house pressure, and redid the gas line adding a sediment trap. We ran a combustion analysis and static pressure test to ensure safe and efficient operation and adjusted fan speeds and gas flow as needed for optimal performance. This entire project is backed by our Golden Guarantees.
A Nytech customer called for a demand plumbing service for what they assumed was going to be a water heater repair for their 3-year-old system - their pilot light wouldn’t light, and they had a steady drip coming from their pressure valve. Our plumber got on the scene and was able to get the pilot to light on their first try, but the main burner would not stay lit and they discovered the expansion tank had failed. Our plumber replaced it and assumed the water heater would be good to go after that. However, that was not the case, and a further investigation was needed. A tank replacement was needed, as our plumber found that the tank was collapsing into the burner chamber and failing due to pressure/thermal expansion issues caused by a closed intake spring. We installed an AO Smith 40 Gallon, 40K BTU - Atmospheric Vent Water Heater, which fully resolved all issues surrounding the water heater so our customer can enjoy stress-free hot water, as this this system is covered by all of our guarantees.
A customer of ours was interested in taking advantage of a replacement promotion we were running for both HVAC systems and water heaters because their systems were nearly 20 years old, so they scheduled a free proposal and decided to move forward with the quotes they were given. It was a big project for Nytech. We installed a new Lennox furnace and A/C with a full duct mod, two new 50-gallon A.O. Smith water heaters, a healthy climate fan-powered humidifier, a big blue water filtration system, and a halo 12. This new installation included the removal of all the old equipment and setting all the new units level and with a slight pitch towards the drain lines. We sealed up all-new joints on the HVAC system, ran new gas lines for the water heaters and furnace, and added sediment traps. We also ran new drain lines for all pieces of equipment, rewired all high and low voltages, added safety shut-offs for the humidifier and A/C, and wired in the humidifier to be controlled through the S30 thermostat. For the water heater and filtration system, we ran new water lines, added new shut offs for hot and cold sides and created a bypass for the filter system, and added a large new expansion tank matched to house pressure at 60 psi. A combustion analysis and static pressure test was run at completion to ensure safe and efficient operation, and all systems are covered by our guarantees.